Ball Joint, Rotor, and U-joint Replacement

The Dana 30 front axle that I swapped to my Scrambler from my 1986 CJ-7 had a bad upper ball joint
on one side. This caused the tire to lean in slightly at the top. I decided to replace all 4 ball
joints, rotors, and axle u-joints. This is not a job I want to do again as it took two full days
with lots of banging on things with a big hammer. I borrowed a ball joint tool from Autozone,
and I would recommend it to anyone thinking of replacing ball joints.

d30yoke.jpg	d30knuckle.jpg	d30spindle.jpg
d30rotor.jpg	d30done.jpg	d30shaft.jpg